Tag Archive for 'Restoration'

Killer Instinct 2 machine is done… for now

So I finally “finished” my killer instinct 2 arcade machine de-conversion.

Here are the changes I’ve made since the last update…

1. Tuned the monitor. The convergence on the monitor was way out of whack because the yoke was lose (missing a few wedges) I replaced the wedges aligned the monitor and build some homemade convergence strips to improve the image. I couldn’t get the convergence perfect but it’s better than it was and everything is secured properly now so it wont be falling out of adjustment again. I also manually degaussed the monitor because it needed it badly.

2. Added a light shield above the monitor glass, it bugged me that the marquee light was leaking into the monitor glass, a small strip of poster-board and some staples fixed that easily.

light_blocker

3. Repaired some of the structural wood that was lose, this picture is of the monitor bezel and glass support, it was coming lose and twisting so I pulled it, put fresh nails in it one size larger and then glued it in place. Now the bezel even lines up with the monitor better than it did before.

ki2_monitor_glass_support

4. Kick panel fill, smooth and wrap. I glued wooden dowels into the holes left from a lock bar, then I bondoed them smooth and filled some rough edges along the bottom. Sanded that and the black portion of the sides smooth. Once everything was dry and smooth I wrapped it in Matte-Black 3M Di-Noc Vinyl (the same stuff they use to wrap cars).

5. Coin doors were powder coated, all the parts cleaned and rebuilt, even put some fresh bulbs and new locks in there.

ki2_kick_panel_4

6. Touched up paint on the control panel box and some scuffs in the side art.

ki2_touch_up_paint_2

for reference here is what it looks like before the touch up paint:

ki2_before_touch_up_paint

7. All new fresh T-Molding

ki2_t-molding

 

There are a few things that still need to be done but I can’t do them until I find the parts…

  1. I need a coin door blank to fill in the bill validator slot
  2. I need a control panel overlay to replace the matte black placeholder I have there now
  3. I need a midway 120mm fan mount for the cooling fan
  4. Not needed but I’d like new graphics for the control panel box front and sides

Sadly none of those parts are readily available so I’ll simply have to keep an eye out and buy them if and when I see them pop up for sale.

Bose 901 Speaker Restoration

I’ve posted up a new hack page detailing a the Bose 901 Speaker Restoration that I recently completed.

Bose 901 Series IV Speaker Restoration